Issue: Cpu Scaling Governor
Issue Description:
We have seen some issues with the scaling cpu governor on the raspberry pi interfere with the i2c bus. This sometimes causes the zymkey to be put into a odd state or return failures from operations that get optimized out by the governor.
Workaround Solution We Recommend!
The raspberry pi sets the scaling governor to be “ondemand” by default. We recommend switching this mode to “performance” to get the best out of the zymkey.
Be warned this will drain more battery power when switched to “performance”!
Set to performance but not persistent on reboot:
- Run as root: sudo su
- echo performance > /sys/devices/system/cpu/cpufreq/policy0/scaling_governor
Set performance to be persistent on reboot with a systemd service:
- Create a .service file in /etc/systemd/system/
- Write this code to .service file:
[Unit]
Description=Set scaling governor to performance
After=multi-user.target
Before=zkbootrtc.service
[Service]
Type=oneshot
ExecStart=/bin/sh -c “echo performance > /sys/devices/system/cpu/cpufreq/policy0/scaling_governor”
[Install]
WantedBy=multi-user.target
- Enable the service: sudo systemctl enable yourservice
- Start the service: sudo systemctl start yourservice